3 Ways to Make Ron Ron Juice

Table of contents:

3 Ways to Make Ron Ron Juice
3 Ways to Make Ron Ron Juice

The ron ron juice is an old acquaintance of fans of the reality show Jersey Shore. Made with vodka, wild fruits and watermelon, the drink is not difficult to prepare. You just need to measure out the ingredients and put them in a blender. However, if your blender is not very powerful, it is possible that you have problems with the watermelon. Stop blending and stir ingredients by hand if blender stalls.


  • 8 cups of seedless watermelon.
  • 350 ml of cranberry juice.
  • 1 ½ cups of blueberries.
  • 1 pot of maraschino cherries.
  • 1 ½ cups of vodka.
  • Ice.


Method 1 of 3: Adding the Ingredients

Make Ron Ron Juice Step 1

Step 1. Cut the watermelon

Before putting the watermelon in a blender, cut it well. Place it on a cutting board and break it in half vertically. Then cut each of the halves in two.

  • Cut each slice in turn into smaller 2-inch slices. Remove the husk.
  • Cut the slices into more or less even cubes. If your blender is weak, try keeping them very small.
  • Cut watermelon to fill eight cups.
Make Ron Ron Juice Step 2

Step 2. Add vodka and cranberry juice

Liquid ingredients should be at the bottom of the blender. That way, it will be easier to beat the drink. Start by adding the vodka and cranberry juice to the pitcher on the appliance.

The order of the liquids doesn't matter. It's just essential that they stay in the background

Make Ron Ron Juice Step 3

Step 3. Add the cherries, watermelon and blueberries

The next step is to put the fruit in a blender. Add watermelon, blueberries and cherries. As it is best to leave the liquid ingredients deeper, pour the cherries into the jar first, as they usually come with juice. That way, the drink will be ready faster.

Make Ron Ron Juice Step 4

Step 4. Add ice

The amount of ice is up to you. It only serves to make the drink cold and thick. The colder and thicker you want the drink to be, the more ice you'll need to use. If your blender jar is small, use less ice so you don't fill it.

Method 2 of 3: Beating the Ingredients

Make Ron Ron Juice Step 5

Step 1. Start in pulsar mode

If your blender has a pulsar mode, use it to start blending ingredients. A lot of people think that the best thing is to start hitting the high power, but that will only make the drink take longer to be ready. For a quick juice ron ron, start with pulsar mode.

Whisk the drink in pulsar mode until it starts to pass smoothly through the blender paddles, without the fruit getting stuck. The ingredients must all rotate together

Make Ron Ron Juice Step 6

Step 2. Increase speed gradually

When the ingredients start to blend, set the blender to low power. Beat for 20 to 30 seconds. Then increase the speed and beat for another 20 to 30 seconds.

Make Ron Ron Juice Step 7

Step 3. Beat until uniform

The drink should be creamy and uniform after it's ready, similar to a smoothie. There should be no fruit left in the ron ron juice.

Method 3 of 3: Solving Blender Problems

Make Ron Ron Juice Step 8

Step 1. Cut the fruit into small pieces if your blender is weak

A powerful blender has less difficulty mixing ingredients. However, if your blender is small and has few speed options, cut the fruit into small pieces. This way, the ron ron juice will be uniform even if your blender is weak.

Make Ron Ron Juice Step 9

Step 2. Pause and stir the ingredients

Even the strongest blenders are slow from time to time, especially when it comes to blending ingredients like fruit. If your blender starts to slow down, turn it off and stir the ingredients with a spoon. This should be enough to loosen the pieces of fruit stuck in the paddles and put the device back on its axis.

Make Ron Ron Juice Step 10

Step 3. Wash the blender immediately after use

The longer you leave the blender dirty in the sink, the more difficult it will be to clean. Wash the jar under running water immediately after use. If the pads are removable, loosen them and wash them separately.

Make Ron Ron Juice Step 11

Step 4. Serve the drink and enjoy


  • Although watermelon seeds are not bad for your health, the drink is creamier without them. Try to find a seedless watermelon or use already unseeded pieces.
  • If your blender isn't big enough to hold all the ingredients at once, blend the drink into smaller portions and mix in a jar before serving.


Popular by topic